Technics QUARTZ SL-MA1 - Page 5

How to remove the stator frame
Ref. No.
4
1. Remove the 4 setscrews.
Procedure
192934 | 2. Cut off the stopper with nippers.
Procedure
19293905
How to remove the LED board
@ Remove 2 setscrews.
How to remove the operation button
and operation circuit board.
. Remove the lead connector FCN301.
2. Remove the ornament plate by pushing it with screw
driver or the like through the hole in the cabinet.
. Remove the 3 setscrews (Q@~ @).
. Remove the 2 setscrews (Q,@).
5. Remove the operation circuit board, unfastening the
claws at 4 portions.
Note: Take care not to damage the claws projected
from the operation button.
Procedure
11> 26
WwW
Screw driver
Ornament ;
plate :
j Operation circuit boari