Technics QUARTZ SL-MA1 - Page 6

5L-MA1
Ref. No.
How to remove the arm base
Procedure
1>2—>7
le
Dy
Control circuit
board
FCN303 C
®
@ 9!
FCN503
3] 4)
eal
01° 4e
ee No. | How to remove the ard drive coil board sae No. | How to remove the magnet
1. Remove the anti-skating knob.
798 2. Remove the setscrew ( @).
3. Unsolder the 5 lead wires.
4. Remove the nut.
5. Remove the 3 setscrews (Q~@Q).
Note: Take care not to break the coil.
Cop anti-skating
knob
Arm drive
coil board
= Phono output cord a
1. Remove the 2 lead connectors (FCN303, 503).
2. Remove the 2 setscrews (@, @) and remove phono
output cord from bracket.
3. Remove the 4 setscrews (Q ~ @).
Bracket
Al
>
\
Lo
Phono output cord
oe
@
Remove
the
2
setscrews.
How to remove the arm position sensor
Procedure | 1, Remove the setscrew ( @).
710 2. Shift the tonearm inside and remove
the screwQ@.
Arm position
sensor
Slide plate