Preset tuning
By presetting the desired broadcast stations into the memory
channels of this unit, broadcast stations can be selected simply
by pressing numeric button(s). (Refer to page 16 for tuning.)
-Before presetting
How many broadcast stations can be preset?
A total of 30 FM and AM stations can be preset.
How Is presetting done?
The two following methods are available.
(_ Automatic memory presetting
Automatic memory presetting allows this unit to
automatically search for broadcast stations and then
preset them into memory.
With this function, searching proceeds from the frequency
currently being displayed and continues through higher fre-
quencies, (up to 107.9 MHz for FM, up to 1710 kHz for AM)
and broadcast stations are preset in the order in which
they are located.
With this method, the channels that can be preset into the
memory are set as follows for different bands (FM or AM).
Channel
--
ForFMbroadcast stations ...................... 1-30
For AM broadcast stations ..................... 21-30
If the FM stations (channels I - 30) are preset end then
the AM stations (channels 21-30) are preset
Because this unit can accommodate a total of 30 preset
channels, the settings for FM channels 21-30 will be
replaced by the AM settings which were subsequently
preset, and the channel allotment will be as shown below.
Channel
I_ FM _ _ AM-_ 1
For FM broadcast stations ...................... 1-20
For AM broadcast stations ..................... 21-30
Manual memory presetting
The desired broadcast stations can be preset Into the
desired channels by the user.
This can also be used as a method for changing selected
broadcast stations that were preset in "Automatic
memory presetting".
Please remember this
If a new broadcast station is preset into a channel, the setting
for the broadcast station which was previously entered in that
channel will be automatically erased.
Automatic memory presetting
f \
_L-' I.... I-'=-! - I-" I -_1'
2
which you want to start
automatic memory preset-
ting. (See page 14.)
quency begins to change.
L \ (Automatic memory presetting will
start.)
During automatic memory presetting,
the memory indicator will flash while
the frequency scrolls.
Flashes
I'-/I-_ t
I-I F/, I ..,
I
To stop, press MEMORY once again.
When a broadcast station Is preset
The memory indicator and the preset channel number will be
displayed for approximately 1 second.
I® I L n
Lights up
J
When presettlng Is completed
The last broadcast station to be preset will be displayed.
Frequencies may not be preset correctly in cases where the
broadcast waves are too strong or too weak. In such cases, carry
out presetting manually.
15
To Next Page
Loading...
Need help?
General
