Technics SC-CH950 User Manual

To
adjust
the
specific
frequency
of
the
equalization
curve
or
simulated
listening
environment
.
Select the desired equalization curve or simulated listening environ-
ment before proceeding to step. (See pages 54-55.)
JOG MODE JOG
©
1
Press
BAND
to
select
the
frequency
band
to
5
Press
SLOPE
(Q)
to
select
the
preferred
slope,
be adjusted.
Each press of BAND advances the frequency band setting
LOW, HIGH1, HIGH2 in sequence.
LOW: 63 Hz-220 Hz
HIGH1, HIGH2: 315 Hz—16 kHz
Turn JOG to select the frequency band you
want to adjust.
Press JOG MODE to select EQ. L (equalizer
level) mode.
The bar under EQ. L lights.
“USER” display will appear.
“narrow” or “wide’’.
The
curve
slope
selection
changes
from
“narrow”
to
“wide”
each time SLOPE (Q) is pressed.
A “narrow” mode: Only the center frequency that is
flashing will be boosted.
“wide” mode: Adjacent frequency level will be also
boosted together with the center fre-
quency.
When
you
want
to
adjust
another
frequency
band
in
suc-
cession;:
1. Press BAND to select the frequency band to be adjusted.
2. Press JOG MODE to select EQ. F (equalizer frequency) mode.
3. Follow the steps 2-5.
@ To shift the curve slope
The curve slope can be shifted only within the range of
63 Hz-220 Hz (LOW) or 315 Hz~16 kHz (HIGH1—HIGH2).
1. Press JOG MODE to select EQ. F (equalizer frequency) mode.
The bar under EQ. F lights.
2. Shift the curve slope using JOG.
@ To adjust the reverberation sound
(Only when you select SFP mode)
1. Press JOG MODE to select EFFECT mode.
The bar under EFFECT lights.
2. Adjust the reverberation sound using JOG. (See page 57.)

Technics SC-CH950 Specifications

General

Brand	Technics
Model	SC-CH950
Category	Stereo System
Language	English