Referencepagesindicatedinblackcircles.(Forexample:9))
J Problem I Probable cause(s) i Suggested remedy l
While using the cassette deck
Tape moves but no sound The input selector of the amplifier is not set to the • Set to the "TAPE MONITOR" position. O
is heard. "]'APE MONITOR" position.
Previously recorded sound Erase head is dirty. • Clean the head. •
has not been erased.
Sound output is hoarse or Heads are dirty. • Clean the heads. O
unsteady. Tape is damaged. • Try operation with a new tape; if there is no problem
with the new tape, discard the damaged tape.
Poor sound quality The Dolby noise-reduction function is off. • PressDOLBY NR button O ..........
(especially in the high treble
and low bass ranges).
Sound is low, poor tone, Heads, capstan and/or pinch roller are dirty. • Clean the heads, capstan and/or pinch roller. •
intermittent sound, noise. • Tape is damaged. . • Try operation with a new tape.
There Is a lot of noise, and The heads have been magnetized. • Demagnetize the heads with a comme_fiaUy sold
the treble Is drowned out. magnetic eraser.
Recording is not possible. One of the tape-to-tape recording-speed indicators Switch off whichever tape-to-tape recording-speed
is illuminated, indicator that is illuminated (by pressing the
SPEED button). O
Recorded sound is TV This unit is placed near a "IV. • Try placing this unit farther away fron_ a "IV.
noise.
While using the digital sound processor or the graphic equalizer,
Equalized sound can't be t The power switch is switched "OFF". • Switch "ON" the power.
heard.
While using the remote control transmitter
Remote control transmitter Batteries are incorrectly installed. • Insert the batteries so that the positive (+) and
does not function, negative (-) polarities are correct. 0
The remote controltransmitterbatteriesare • Replacethem with new batteries.
drained.-
There is an obstruction between the remote control • Remove the obstruction.
transmitter and the system components.
The rem6te control transmitter is not correctly • Face the remote control transmitter correctly
facing the system components, toward the system components. O
Product service
Do not attempt to remove the cover(s) or repair the unit
yourself.
Refer servicing to qualified personnel only.
Productinformation
For product service, product information or assistance in
product operation, refer to the servicenter directory.
When getting service
Before bringing in your changer for service, be sure to remove all
discsfirst.
If the disc in play doesn't return to its slot when you press m, hold
the button down for about 4 seconds. The disc should return to the
slot.
To Next Page
Loading...
