Technics SH-AC500D

SH-AC500D
Start playing the sound source.
The surround indicators
@) DO DIGITAL: Lights if the source is Dolby Digital Format.
© GZS: Lights if the source is DTS format.
© OO PROLOGIC: Lights when Dolby Surround parts of
Dolby Digital format software are
played back, or when playing audio
CDs in the SURROUND mode.
eOnly Dolby Digital, DTS or PCM signals > can be
(a)
[
oa
DIGITAL
S
‘
reproduced.
The
digital
input
signal
of
sampling
frequencies
96
kHz
and
other
signal
formats
such
as
MPEG
cannnot
be
reproduced
on this unit.
fats]
+
j
tei
eWhen
playback
is
started,
the
sound
may
be
cut
or
i
i
interrupted
before
the
input
source
is
confirmed
as
Dolby
Digital or DTS.
Gd viata
* PCM signal: This refers to the recording format of signals
(44.1 kHz, linear 16 bits) used for audio CDs
[PRO Loic
6! Adjust the volume.
Set the volume on the receiver (or amplifier) and this unit to
the initial level. Any subsequent volume adjustments
VOLUME should be done as follows.
[A (When this unit is connected to a receiver (or amplifier)
that has 6 channel discrete input terminals:)
Adjust the volume using the volume
\ y
DOWN
control
on
the
receiver
(or
amplifier).
If
input
to
the
receiver
(or
amplifier)
is
excessive,
reduce
the
volume
on
this
unit
slightly.
‘B| (When this unit is connected to three standard stereo
amplifiers or three integrated amplifiers:)
Adjust the volume using this unit’s
VOLUME control.
To adjust the volume of the components connected to the
stereo control amplifier, use the volume control on the
stereo control amplifier.
After use
Reduce the volume on the component you are using to contro! the
volume (the receiver, amplifier or this unit) to the minimum level,
then turn off the power to this unit and the other components.
as 43