Technics SL-DL1 - DISASSEMBLY INSTRUCTIONS; Removing Bottom Board and Main P.C.B.; Removing the Stator Frame; Removing the Cartridge

eo] |
m@ DISASSEMBLY INSTRUCTIONS ¢ How to remove the cartridge
1. Open the upper cabinet and turn the arm lock in the direction of the
arrow to lock the tonearm.
Sian
ecblaae
lt
tadgiiel
riretoanies
main
P.C.B
©
de.
9)
2.
Loosen
the
cartridge
setscrew
with
the
screwdriver.
(Turn
the
set-
.
;
‘
F
0
i
i
4)
screw
until
it
is
freed
as
shown
in
Fig.
5.)
2.
Turn
era
jas
sae
down,
renin
nek
—
cloth:
or
the
like
8
AS
05]
iz
3.
Pull
out
the
cartridge,
taking
care
not
to
touch
the
stylus.
(Fig.
6)
asac
0
protect
the
upper
cabi nd
dust
cover.
insulator
~Q
|
;
;
:
3.
Remove
the
insulator
and
bottom
board
setscrews
@~
@.
Then
the
3
©
o
FO
sii
eee
Teer
niene:
oe
ee.
Entel
coeector
wi
, Bottom board b d, (See Fig. 1) : Insulator the cartridge pin and completely insert the cartridge and tighten
ottom board can be removed. (See Fig. aris e thesetscrew. (Fig. 6)
4. Remove the rear cover setscrews (@ and @® to remove the rear cover. Le
(Fig. 2)
5. Remove the main P.C.B. setscrews @ ~ @ and connectors @ ~ @. Then
the main P.C.B. can be removed. (See Fig. 3)
*When installing the main P.C.B. onto the main body, make sure that the
connector @ (CN102) is engaged with the stator frame pin. (Fig. 3) Bottom board
% Please note that the front Fig. 1
and rear insulator springs
are different from each
other.
Front. .... | White
Rear ...... Yellow
e How to remove the surface plate and dust cover
1. Remove the cartridge. (Refer to ‘How to remove the cartridge’”.)
2. Open the upper cabinet and push the scale part of the surface plate
from inside. (Fig. 7)
* Carefully remove the surface plate since it is secured with double-
sided tape.
3. Remove the dust cover setscrews @ ~ @ . (Fig. 8)
4. Completely open the dust cover; remove the upper cabinet cover
setscrews @) ~ @ ; and remove the upper cabinet cover while
pulling the tonearm in the direction of the arrow. (Fig. 9)
5. Remove the dust cover setscrews @ and @ .
Then the dust cover can be removed by pulling it in the direction of
the arrow. (Fig. 10)
Main P.C.B.
Fig. 3
e How to remove the stator frame
1. Remove the main P.C.B.
(Refer
to
“How
to
remove
the
bottom
board
and
main
P.C.B.”)
2. Remove the stator frame setscrews @ ~ €). Then the stator frame
can
be
removed.
(Fig.
4)
®—
j
Surface plate
Stator
frame
Fig. 4