Technics SL-PC25

eee Removal of the loading chassis Removal of the servo P.C.B.
Procedure
|
1.
Remove
the
7
screws
(O~@).
Procedure
°
8-10
2.
Remove
the
2
connectors
(CN301,
8-10-11
CN451).
Servo P.C.B.
SS Spindle motor terminals
1. Remove the 3 screws (O~®).
2. Unsolder the 2 terminals of spindle motor.
3. Remove the FPC board from the optical pickup.
Caution: To prevent the breakdown of the laser
diode, antistatic shorting pin is inserted
into the FPC board.
eae Removal of the optical pickup aa Removal of the loading motor
Procedure Procedure
8-10-12 8-10-13
Refer to the handling precautions for |
optical pickup and instructions for |
| traverse oil (See page 8).
. Remove the drive belt.
. Remove the 3 screws (@~®).
. Release the 2 claws.
. Unsolder the 2 terminals of the loading
motor.
PON =~
1. Remove the 2 screws (@, @).
2.
Unsolder
the
2
terminals
and
the
2
screws
(@,
@).
ie
0)
y iN mS :
Drive belt
Unsolder
Caution:
Take
care
not
to
touch
the
brush
terminal.
ceed
aie
ee
minale
ee