Technics SL-PD1010 - Page 19

[Start recording on the tape deck and
then immediately:]
Press ► .
When the last track set for recording on side A is finished, the
changer wilt enter the pause mode, Set the tape to the position
from which recording will begin on side B, and then perform step
4 once again.
When all the programmed tracks on the specified disc finish play¬
ing, the changer will automatically stop. The edit guide mode will
be canceled at the same time,
To enter a desired recording time other than 46,
60 or 90 minutes:
1. Select “C—” in step 3.
2. Enter the total recording time in minutes (1-99) using the
numeric buttons.
For example:
To use 52-minute tape, press 5 then 2,
You can also specify the tape length pressing the SKIP button.
Press either or from each step C-46, C-60, C-90 or C--.
For example:
To use 52-minute tape, select C-46 and then press and hold
until the display shows ‘‘52’'.
The maximum allowable playing time for editing is 99 minutes.
To stop recording
Press ■ and then press the stop
button on the tape deck.
imrt
Depending on the disc, a little of the beginning of the next track
may be recorded onto the end of the track.
For your reference:
When this unit is in memory reserve mode, this mode wilt be
canceled when EDIT GUIDE is pressed. After finishing recording,
press OFF/ON again if you wish to reset the unit to memory
reserve mode,
(Only available from the remote control.)
The various time information of the current disc can be
displayed.
TIME MODE
[In the play or pause mode]
Press TIME MODE.
The Information will change (as described
below) each time you press the button.
•CD Track number and elapsed play time of the
current track
^
1 -I OHO
disc _'nua mm age
►
(D Total remaining time on the disc
VT7
1 -60: IB
DSC MM 8EC
►
(D Track number and remaining time of the
current track
/ -j- 003
disc _Jtmcx min sec
►
© Total elapsed play time on the disc
l
V< L />
1 S'-Hl
W3C MIN SEC
►
In all play modes:
When track number 21 or greater Is playing, display (3) shows
In program/delete/random/spiral mode:
The displayed information will alternate between displays © and
d) each time the button Is pressed.
During operation of the edit guide function:
The remaining play time on side A or side B will be shown in
display ©, and the elapsed play time for side A or side B will be
shown in display ©.
When you stop playing and then start play again, the display will
return to display ©.