Technics SL-PJ28 - Page 2

SL-PJ28
@ ACCESSORIES
AC power supply cord....... 1
(SJA187) ... (SJP2249-3)
(RJA0004) ..
(SJA173)
M@ BEFORE USE
Be sure to disconnect the mains cord before adjusting the voltage
selector.
Use a minus (-) screwdriver to set the voltage selector (on the rear
panel) to the voltage setting for the area in which the unit will be
used.
Mi CONNECTIONS
Notes:
¢Tum off ali components before making connections.
© See the operating instructions of the tuner for details.
e
To the “CD” terminal of the
amplifier
[1] Stereo connection cable (included)
[2] L-type cable (inciuded)
This cable can be used only with a Technics cassette deck
having the appropriate “SYSTEM CONTROL OUT’ terminal.
[3] L-type cable (notinciuded) =...
This cable is included in a Technics graphic equalizer having
the appropriate “SYSTEM CONTROL IN" terminal.
¢ Stereo connection cable... 1 pc.
[3}-—)
To the “SYSTEM CONTROL IN”
terminal of the graphic equalizer
2] =
To the “SYSTEM CONTROL
OUT” terminal of the
cassette deck
¢ L-type CABLE Lc ccccceseneee pc. © Power plug adaptor
{SJP2257T) (For (GC) onty)
(SJP9215)
Ee
{if the power supply in your area is 117 V or 120 V, set to the
“127 V" position.)
Note that this unit will be seriously damaged if this setting is not
made correctly. (There is no voltage selector for some countries;
the correct voltage is already set.)
Rear panel
of this unit
To the "AC OUTLET” of the
amplifier or to a household AC
outlet
[4] “UNSWITCHED” outlet
Power is always available, regardiess of power switch. Audio
equipment rated up to 50 W can be connected here.
[5] AC power supply cord (included)
Note:
The configuration of the AC outlet and AC power supply cord
differs according to area. :
For (GC) only -
Whe POWET HIG Will NOT Tit yOUr SOCKaL, Use the power piug
adaptor (included).
po Sef] >
| SL-Pu28
Mi PRECAUTION OF LASER DIODE
CAUTION:
This
product
utilizes
a
laser
diode
with
the
unit
turned
“on”,
invisible
laser
radiation
is
emitted
from
the
pick
up
tens.
Wave
length:
780nm
Maximum output radiation power from pick up: 100HW/VDE
Laser
radiation
from
the
pick
up
tens
is
safety
tevel,
but
be
sure
the
followings:
1.
Do
not
disassemble
the
optical
pick
up
unit,
since
radiation
from
exposed
laser
diode
is
dangerous.
Se
2.
Do
not
adjust
the
variable
resistor
on
the
pickup
unit.
1t
was
already
adjusted.
3. Do not look at the focus lens using optical instruments.
4. Recommend not to iook at pick up lens for a long time.
ACHTUNG:
Dieses
produkt
enthailt
eine
taserdiode.
Im
eingeschalteten
zustand
wird
unsichtbare
laserstrahiung
von
der lasereinheit
adgestrahit.
Wellenlange: 780nm
Maximale strahlungsleistung der lasereinhelt: 100 h}W/VDE
Die
strahlung
an
der
lasereinheit
ist
ungef4hriich,
wenn
folgende
punkte
beachtet
werden:
4.
Die
lasereinheit
nicht
zerlegen,
da
die
strahlung
an
der
freigelegten
laserdiode
gefahriich
ist.
2.
Den
werksseltig
justierten
einsteliregier
der lasereinreit
nicht
verstellen.
3. Nicht mit optischen instrumenten in die fokussierlinse blicken.
4. Nicht Ober langere zeit in die fokussierlinse blicken.
ADVARSEL: | dette a apparat anvendes laser.
RQLS0051
VARO! Avattaesse j2
suojatukites ohitettee-
ssa olet alttiine
lasersitellylle,
Ai kato ‘sdioeseoe
e Use of caution labels
Note: © Mark is used, x Mark is not used.
CLASS 1
LASER PRODUCT
town?
Obs:
Apparaten innehaller laser
Komponent av héger laserklass
an klass 1.
‘ROLSO0S1
RQLS0021
DANGER-Invisible
laser radiation when
open.
AVOID DIRECT EX-
POSURE TO BEAM.