Technics SL-PJ28 - Page 4

SL-PJ28
|
SL-PJ28
@ DISASSEMBLY INSTRUCTIONS
Removal of the main P.C.B.
Warning: This product uses a laser diode. Refer to caution statements on page 3.
ACHTUNG: »° Die lasereinhelt nicht zeriegen.
¢ Die iasereinheit darf nur gegen eine vom herstelier spezifizierte einhelit ausgetauscht
werden. 3
>< This CD player is equipped with FPC boards, so handle them with care during disassembly and reassembly.
Rosie Removal of the cabinet Bates Removal of the front panel ass’y ;
Procedure
Troverse
1
AC outlet cover
Power supply P.C.B.
Claw
1. Remove the 2 flat cables (CN11, CN301).
2. Remove the 1 connector (CN302).
3. Remove the 4 screws (@~®).
Ref. No.
- 6
Procedure
1-2-6
1. Remove the 1 flat cable (CN701).
2. Remove the 3 screws (0~®@).
3. Release the 2 claws of the AC outlet cover.
Removal of the fixed plate, magnet
and magnet holder ass’y
Removal of the clamping plate
ass’y
Procedure
1-2--6-7 :
Conversion lever Fixed plate
1. Push the conversion lever fully in the direction of
arrow @ and lower the traverse deck.
2. Move the disc tray in the direction of arrow @.
Magnet
Magnet holder
ass'y
Procedure
12-3
¢ Release the 3 claws.
= ;
Ref.
No.
.
Ref.
No.
Removal
of
the
tray
guide
shaft
and
8
Removal
of
the
loading
unit
9
guide
holder
end
~~ | Procedure e
1-2-6 a
.
Release
the
2
claws
and
then
remove
the
tray
+89
oe
aa
ornament
in
the
direction
of
arrow
3.
uide
shaft
holder
Tray guide shaft
Front panel
assy
¢ Remove the 8 screws (@~@).
1.
Remove
the
1
flat
cable
(CN301).
1.
Remove
the
3
screws
(@~@).
2.
Remove
the
1
connector
(CN302).
2.
Remove
the
tray
guide
shaft
and
guide
holder
in
3.
Remove
the
4
screws
(@~®).
the
direction
of
arrow.
4. Remove the 2 screws (@, @).
5. Remove the front panel ass’y in the direction of
arrow °4.