Technics SL-QL5 - Removing Internal Boards and Cabinets

On> @
How to remove the operation circuit board
. Remove the bottom board. (Refer to ‘‘How to remove
the bottom board.’’)
. Remove the 7 operation circuit board setscrews Fig. 5:
@~®) and the stopper.
How to remove the drive circuit board and
stator frame
. Remove the operation circuit board (Refer to ‘‘How to
remove the operation circuit board.’’)
. Remove the 4 setscrews (Fig. 6: @~@) of the stator
frame.
. Pull out connector CN101, then remove the drive cir-
board with stator frame.
. Cut off the stopper by nippers and remove the 4 set-
screws (Fig. 7: @~@) to separate the drive circuit board
and stator frame.
© ©
Drive Circuit board
Connector
Z
= \
Stator Frame
How to separate the upper cabinet and lower cabinet
Remove the bottom board. (Refer to ‘‘How to remove the bottom board.’’)
Pull out the 2 connectors (CN301, CN401) from the operation circuit board. (Fig. 8)
Remove the 4 hinge setscrews (Fig. 9: @ ~ @) and the phono output jack.
Release the claws and slowly lift the lower cabinet to separate it from the upper cabinet.
Fig. 8
i
u
~
™S
Stopper-—~ <7 3)
¥
Operation
Circuit board
Fig. 5
@
‘i
@ Stopper
; / ®
Stator Frame
Drive Circuit board
Fig. 7
Phono Output Jack