Technics SX-E33 - Page 6

DISASSEMBLY
INSTRUCTIONS
. Top Cover
a)
Remove
the
2
setscrews
®
located
on
the
right
and
left
side
of
the
top
cover.
b)
Remove
the
6
setscrews
®
located
on
the
rear
panel.
c)
The
top
cover
can
be
remeved
upwards.
2. Sliding Cover
a)
Unlock
the
sliding
cover
with
the
accessory
key.
b)
After
removing
the
top
cover,
remove
the
sliding
cover
in
its
fully-closed
position.
[Fig.-6]
.
Control
Panel
(Upper
Side)
a)
Remove
both
top
cover
and
sliding
cover
according
to
procedures
1
and
2.
b)
Remove
the
3
red
screws
@
which
fasten
the
con-
trol panel.
c)
Then
the
control
panel
can
be
open
upwards.
4.
Keyboard
&
End
Cover
Unit
a)
Open
the
control
panel
according
to
procedures
1,
2
and
3.
b)
Remove
the
8
setscrews
®
on
the
bottom
of
the
shelf-board.
c)
Then
the
keyboard
&
end
cover
unit
can
be
opened
upwards.
,
. Upper Keyboard
a)
Open
the
keyboard
and end
cover
unit
according
to
procedure
4.
b)
Remove
the
6
setscrews
@
which
fasten
the
upper
keyboard
chassis.
c)
Then
the
upper
keyboard
can
be
removed.
. Lower Keyboard
a)
Open
the
keyboard
and end
cover
unit
according
to
procedure
4.
b)
Remove
the
4
setscrews
@
which
fasten
the
lower
keyboard
chassis.
c)
Then
the
lower
keyboard
can
be
removed.