Technics SX-KN901

ERROR DISPLAY
Contents
No. Contents
00 The data on the disk that you are using
is for a different product.
01 An error has occurred while the disk was
loading.
Please try again!
02 There is no disk in the Disk Drive.
The file that you tried to load is empty.
05 An error has occurred while the disk was
saving.
Please try again!
06 The disk that you are using is write
protected.
Please remove the write protection and
try again.
07 The disk that you are using is full. Please
use another disk.
An error has occurred while the disk was
formatting. The disk that you are using
may be faulty.
Please try formatting another disk.
09 The data on the disk is copy protected.
10 The data is already copy protected.
20 A problem has occurred with your
SEQUENCER Data.
This might be due to a damaged or faulty
disk.
21 Memory full
23 It is impossible to change the time
signature because it has already been set
in the existing tracks.
24 A rhythm track already exists. It is
impossible to assign two tracks to rhythm.
28 This song is too long to be saved as a
MIDI file.
29 The MIDI file that you have tried to load
exceeds the memory capacity of this
instrument and cannot be played. The
SEQUENCER memory has been cleared.
It is not possible to change the time
signature or measure length of a
COMPOSER patiern after it has been
recorded. If you want to proceed, you
must first clear the entire COMPOSER
pattern.
31 The time signature of the pattern from
which you are copying is different from
the COMPOSER memory that you are
using.
Either: Change the time signature
of the COMPOSER memory
or: Copy from a pattern that has
the same time signature
Memory full
The Identification (ID) code of the system
exclusive data received by this instrument
is for a different product.
41 An error has occurred during system
exclusive data reception. The data from
the transmitting device may _ be
incomplete.
Please try again.
An error has occurred during system
exclusive transmission. The data has not
been received correctly.
Please try again.
The file that you are trying to load was
saved on a previous KN Keyboard. It is
only possible to load using the “ALL”
option.
It is impossible to edit a KEYBOARD
PERCUSSION.
Please select a different sound from any
group except Keyboard Percussion.
Incompatible disk format.
Please select a preset pattern (00-99).
Please select a user bank (10-12).