Technics SX-KN901

Phenomenon
Remedy
Storage is not possible.
«The remaining memory capacity of the SEQUENCER
is 0. Follow the SEQUENCER CLEAR procedure to
erase the memory.
@The playback track has been selected, but the
START/STOP button has not been pressed. A flashing
track indicator shows the track which is ready for
recording, and a lit track indicator shows a track which
is ready for playback. To record one track while
listening to another (playback) track, press the
START/STOP button to begin playback.
eThe number of measures corresponds to the time
signature of the rhythm selected at the start of
recording. To change the rhythm in the middle of the
song, record the rhythm change in the RHYTHM part.
e[n the RHYTHM SELECT section, a rhythm in
MEMORY A or MEMORY B with no stored pattern was
selected. Select a different rhythm.
No sound is produced for the automatic accom-|eAn ACCOMP part does not sound if its corresponding
volume is set to the minimum level. Use the respective
balance buttons to set the ACCOMP 1, 2 and 3
volumes to appropriate levels.
e The part is muted.
Storage is not possible. eThe remaining memory capacity of the COMPOSER
is 0.
e The time signature and number of measures cannot
be changed for a pattern which is currently recorded
in the COMPOSER. If you wish to change the time
signature and/or measure data, first follow the
procedure to clear the memory.
e The QUANTIZE function was on when the pattern was
recorded and the timing was automatically corrected.
Set the quantize level to a smaller note unit or to OFF
when recording.
e This occurs when the Disk Drive is reading a disk. It
does not indicate a problem.
When the procedure to load from a disk is per-|* When performing the load operation from a disk, the
keyboard memory changes to that of the data loaded
from the disk. If you wish to preserve a song which is
stored in the keyboard memory, save it on a disk before
performing the load procedure.
Multi-track storage is not possible.
cc
Wi
iS)
z
Wi
>
o
Ww
77)
The playback measure indication is different from
when the performance was recorded.
No sound is produced for the automatic accom-
S paniment.
ie)
xr
oO
> :
< paniment, or only the sounds of some parts are
Q | produced.
co)
=
>
zt
Setting the time signature and number of measures
cc {is not possible.
Ww
o”
fe)
QO.
=
(2)
© |The playback timing of the rhythm pattern is
different from the timing with which it was recorded.
The Disk Drive produces a noise during recording
or playback.
®
2
a formed, the contents of the keyboard memory are
%@ |erased.
a
Noise from a radio or TV can be heard.
o
p=
(e)
@This sometimes occurs when electrical equipment
such as a radio or TV is used near the instrument. Try
moving such electrical equipment further away from
the instrument.
eThe sound may be coming from a nearby broadcast
station or amateur radio station. If the sound is
bothersome, consult your dealer or service center.
The cabinet becomes warm during use.
e This instrument has a built-in power source that heats
the cabinet to some degree. This is not an indication
of trouble.
I-11