Technics SX-KN901

SYMPTOMS WHICH APPEAR TO BE SIGNS OF TROUBLE
The following changes in performance may occur in the Technics Keyboard but do not indicate trouble.
Phenomenon
Remedy
The buttons, keys, etc. malfunction.
e Turn off the POWER button once, then turn it on again.
If this procedure is not successful, turn off the POWER
button once. Then, while pressing the 0, 1 and 2
buitons in the RHYTHM SELECT/MODE SET section
at the same time, turn the POWER button on again.
(Note that, in this case, all programmable settings,
functions and memories return to their factory-preset
status.)
No sound is produced when the keys are pressed.
The type of effect does not alternate when the
CHORUS/FLANGER button is pressed.
The volume is very low when the keyboard is
Some sounds cannot be selected.
The sound you hear is different from the sound you
2
Oo
£
7)
xe}
c
©
oo
xo]
¢c
Ss
°
no
played.
selected.
The rhythm does not start.
£
=
~
<=
a
e The MAIN VOLUME is at the minimum setting. Adjust
the volume with the MAIN VOLUME control.
eThe volumes for the selected parts are set to the
minimum levels. Use the balance buttons to set the
volumes of the relevant parts to appropriate levels.
eThe LOCAL CONTROL for a part performed on the
keyboard is set to OFF. Set the LOCAL CONTROL to
ON.
e Follow the procedure to select the type of effect.
eThe volume setting in the SEQUENCER contents is
very low. Follow the INITIAL procedure to reset the
settings.
eWhen the GENERAL MIDI status is set to on, The
sounds which can be selected and operation which
can be executed are limited. Turn the GENERAL MIDI
status off to return the instrument to its normal
operation.
eThis sometimes occurs when you play back
SEQUENCER or COMPOSER data which was created
on a different model, or when MIDI data is received
from a connected instrument. Select the desired
sounds again.
e The DRUMS volume is set to the minimum level. Use
the balance buttons to set the DRUMS volume to an
appropriate level.
eln the RHYTHM SELECT section, a rhythm in
MEMORY A or MEMORY B with no stored pattern was
selected. Select a different rhythm.
e A SEQUENCER track button is on. When you are not
playing back the SEQUENCER performance, turn off
the track buttons.
e CLOCK is set to MIDI [MID]. Set CLOCK to INTERNAL
[INT].
e The rhythm does not work when the GENERAL MIDI
mode is set to ON. Turn the GENERAL MIDI status off
to return the instrument to its normal operation.