Technics SX-KN930

Removing
the
BATT
(+)
and
BATT
(-)
[6]
Removing
the
Disk
Drive
unit
printed
circuit
board
1.
Open
the
cabinet
(see
step
[1])
1.
Open
the
cabinet
(see
step
[1]
)
2.
Remove
the
Disk
Drive
unit
mounting
screws
2.
Remove
the
angle
mounting
screw
(@
4
pcs.).
(@ 4 pcs.).
3,
Pull
out
the
BATT
(+)
and
BATT
(-)
P.C.B.
from
the cabinet.
[Fig. 6]
Disk Drive unit
a |