Technics SX-PR1000 - Page 14

8.11. Removing the Disk Drive unit
1. Remove the keyboard cover (see step “Removing the keyboard
cover ”).
2. Pull out the connector from the Disk Drive unit.
3. Remove the chassis on which Disk Drive unit is attached (I x 4
pcs.).
4. Remove the Disk Drive unit mounting screws (J x 4 pcs.).
8.12. Removing the monitor speakers
1. Remove the keyboard cover (see step “Removing the keyboard
cover ”).
2. Remove the monitor speaker mounting screws (K x 4 pcs.).
Figure-14
8.13. Removing the LCD, INVL P.C.B.
14