Technics SX-PR700 User Manual

SYMPTOMS WHICH APPEAR TO BE SIGNS OF TROUBLE
The following changes in performance may occur in the Technics Digital Ensemble but do not indicate trouble.
Phenomenon Remedy
The buttons, keys, etc. malfunction. e Turn off the POWER button once, then turn it on
again. If this procedure is not successful, turn off
the POWER button once. Then, while pressing
the three lower left buttons in the RHYTHM
GROUP section (ROCK, FUNK & FUSION and
TRAD DANCE) at the same time, turn the
POWER button on again. (Note that, in this case,
all programmable settings, functions and
memories return to their factory-preset status.)
eThe MAIN VOLUME is at the minimum setting.
Adjust the volume with the MAIN VOLUME
control.
e The volumes for the selected parts are set to the
minimum levels. Use the balance buttons to set
the volumes of the relevant parts to appropriate
levels.
e The part is muted.
eThe local control for a part performed on the
keyboard is set to OFF. Set the local control to
ON.
eilnthe SOUND GROUP section, the KEYBOARD
PERC button is on.
e The volume setting in the SEQUENCER contents
is very low. Follow the INITIAL procedure to reset
the settings.
eWhen the GENERAL MIDI status is set to on,
The sounds which can be selected and operation
which can be executed are limited. Turn the
GENERAL MIDI status off to return the
instrument to its normal operation.
No sound is produced when the keys are
pressed.
Only percussive instrument sounds are
produced when the keyboard is played.
The volume is very low when the keyboard is
played.
Sounds and effects
Some sounds cannot be selected.
eThis sometimes occurs when you play back |
SEQUENCER or COMPOSER data which was
created on a different model, or when MIDI data
is received from a connected instrument. Select
the desired sounds again.
The sound you hear is different from the sound
you selected.
The sustain does not work even when the
sustain pedal is depressed.
e The sustain pedal is not connected. Connect the
pedal cord firmly to the PEDAL IN terminal on
the back of the instrument.
eWhen the SUSTAIN PEDAL button is off, the
sustain does not work even when the pedal is
depressed. Turn on the SUSTAIN PEDAL button.
The sostenuto pedal and soft pedal do not)« Different functions can be programmed in these
operate properly. For example, when the soft; pedals. You can return the pedals to their original
pedal is depressed, the rhythm starts ora fill-in} functions by turning off the instrument once, or
is played. by using the PEDAL SETTING mode.

Technics SX-PR700 Specifications

General

Brand	Technics
Model	SX-PR700
Category	Musical Instrument
Language	English