Technics SX-PR700

Removing the printed circuit boards
« Remove the top cover (see step [1]).
e Pull out the connectors on the printed circuit boards.
DA P.c.B.
1. Remove the MAIN P.C.B. mounting screws (@ 2
pcs.).
2. Release the claws of the 2 P.C.B. holders.
HGH P.c.B.
1. Remove the AS P.C.B. mounting screws (@ 2 pcs.).
2. Release the claws of the 5 P.C.B. holders.
P.C.B.
1. Remove the MAIN P.C.B.
2. Remove the JACK P.C.B. mounting screws (@ 3
pcs.).
3. Remove the ground wire holding screws (@ 2 pcs.).
Wed P.c.B.
RXeg P.c.s.
BGM P.c.3.
1. Remove the keyboard assembly (see step [4]).
2. Remove the HP P.C.B. mounting screw (® 2 pcs.).
3. Remove the ground wire holding screw (@ 1 pc.).
4. Remove the headphone jack mounting nuts (O 2
pcs.).
P.C.B.
¢ Release the claws of the AC IN connector bracket.
Eee P.c.s.
1. Remove the control panel (see step [3)).
2. Remove the LCD P.C.B. mounting screws (@ 4 pcs.).
[9] Removing the Disk Drive unit
1. Pull out the Disk Drive unit from the connector.
2. Remove the chassis on which Disk Drive unit is at-
tached (@ 4 pcs.).
3. Remove the Disk Drive unit mounting screws (@ 4
[Fig.13]