Technics SX-PR700

Phenomenon
Remedy
COMPOSER
Storage
is
not
possible.
eThe
remaining
memory
capacity
of
the
COMPOSER is 0.
Setting the time signature and number of
measures is not possible.
eThe time signature and number of measures
cannot be changed for a pattern which is
currently recorded in the COMPOSER. If you
wish to change the time signature and/or
measure data, first follow the procedure to clear
the memory.
The playback timing of the rhythm pattern is
different from the timing with which it was
recorded.
e The QUANTIZE function was on when the pattern
was recorded and the timing was automatically
corrected. Set the quantize level to a smaller note
unit or to OFF when recording.
Disk Drive
Other
|The Disk Drive produces a noise during
eThis occurs when the Disk Drive is reading a
disk. It does not indicate a problem.
recording or playback.
When the procedure to load from a disk is
performed, the contents of this instrument’s
memory are erased.
e When performing the load operation from a disk,
this instrument’s memory changes to that of the
data loaded from the disk. If you wish to preserve
a song which is stored in this instrument’s
memory, save it on a disk before performing the
load procedure.
eThis sometimes occurs when _ electrical
equipment such as a radio or TV is used near
the instrument. Try moving such electrical
equipment further away from the instrument.
eThe sound may be coming from a nearby
broadcast station or amateur radio station. If the
sound is bothersome, consult your dealer or
service center.
Noise from a radio or TV can be heard.
The cabinet becomes warm during use. e This instrument has a built-in power source that
heats the cabinet to some degree. This is notan
indication of trouble.