Technics SX-PX226/M

Transmitting PROGRAM CHANGE numbers
This piano can be used to transmit desired PRO-
GRAM CHANGE numbers to the connected in-
strument.
While pressing the MODE SET button, using the
numbers on the keyboard illustration below for
reference, press a black key to specify the BANK
and a white key to specify the NUMBER. (Refer
to the PROGRAM CHANGE number table.)
INITIAL
e PROGRAM CHANGE numbers аге trans-
mitted by combining a BANK and NUMBER to
specify the desired PROGRAM CHANGE
number 0-127.
e The selected PROGRAM CHANGE number is
shown on the display.
e While pressing the MODE SET button, turn on
the left TRANSPOSE button (DOWN) before
specifying the PROGRAM CHANGE number
for the LEFT part. (The setting which is active
when the MODE SET button is pressed is
always the right TRANSPOSE button [UP],
which is for the RIGHT part.)
PROGRAM CHANGE number table
o You сап also use the sound buttons to specify e For OTHER SOUNDS, the currently selected
the PROGRAM CHANGE number. SOUND number (0 to 17) is transmitted.
e The ORGAN PRESETS are assigned numbers
9 to 17 in the CLASSICAL, JAZZ numerical
order and change depending on the sound
selected at that time.
o Ee SOUND SOUND
EH D LN SOUNDS в- GRAND UPRIGHT ROCK E PANO 1 Enan ти "ES STRINGS YOCAL РА TI
o o a o
o- 9-
z
ABBA
MOE
EYEE