12
Use and Care
Residual Heat
Each cooking zone is equipped with a residual heat warning device.
After any zone is switched off, a ‘ ’ will appear on the display. This
warns that the cooking zone is still very hot. Cooking can be
restarted while the ‘ ’ is illuminated.
Control Circuit Board Thermal Protection
If the cooking zones cause overheating of the internal electronic
circuit board, the heat will be switched off automatically. This
switches off power to the front zones, and the letters ‘ ’ and ‘ ’
flash alternately. If the circuit board does not cool down, power to all
the cooking zones is switched off, and is displayed.
Cooking can be resumed once the temperature has dropped below
the safety threshold.
Operator Error
If you make a mistake when using the push-buttons, an appears
on the display; it will remain there as long as you continue to press
the wrong button.
Switching off the cooking zones
The cooking zones are switched off when the display indicates ‘0’.
The zone wiIl automatically switch off approximately 5 seconds after
the display shows ‘0’.
If the cooking zones are hot, the blinking residual heat ‘ ’ will
appear after they are switched off.
Switching off the hob
To switch the appliance off, hold down switch icon for 1 second.
This will switch all cooking zones off, even if they are in use or the
lock-out function is active. The hob will switch off completely.
If the cooking zones have just been used, ‘ ’ will be displayed
after the hob is turned off to warn that they are still hot.
To Next Page
Loading...
