15
Installation
IMPORTANT: Installation, assembly and electrical
connections must be carried out by authorised personnel.
Building into kitchen benches
The following operation requires building and/or carpentry work,
which must be carried out by a competent tradesman.
Installation can be carried out on various materials such as
masonry, metal, solid wood or plastic laminated wood as long as
they are heat resistant to a temperature of 90°C.
Create an opening with the dimensions shown in the diagrams
below in the top surface of the bench, keeping a minimum
distance of 50 mm from the rear edge and 150mm from the side.
Make sure there is a minimum of 650 mm between the hob and
any shelf, Rangehood or exhaust fan that may be installed directly
above the hob.
The diagrams above illustrate the cut-out sizes, clearances to rear
wall, side walls and overhead combustible surfaces. If you decide
to install the hob flush with the bench surface, then it is essential
to refer to your actual appliance before making any cuts.
20 40-
50
1
2
7
3
4
9
3
0
mn
5
i
.
650
300mm Hob
20
-40
50
1
750
490
50
min.
650
800mm Hob
2 0
0-4
50
1
88
5
3
3
5
50 min
.
650
900mm Hob
20-40
50
1
560
49
0
50
m
in
.
650
600mm Hob
700mm Hob
To Next Page
Loading...
