17
Installation
Electrical Connection
Fit a plug that is appropriately rated for the load indicated on the
data plate to the cable supplied with the appliance. The plug must
be compatible with the socket outlet fitted to the final sub-circuit in
the fixed wiring that is intended to supply this appliance.
If connecting the cable directly to the mains, install a suitable
isolating switch with a minimum contact opening of 3mm between
the appliance and the mains. The isolating switch should be sized
according to the load on the data label and should comply with
current regulations (the earth wire should not be interrupted by the
circuit breaker).
Connection to the electricity supply must be made by an authorised
person in accordance with the Wiring Rules AS/NZS3000. Ensure
the supply cable cannot contact any hot surfaces.
Immediately after installation carry out an inspection test of the
appliance. If the appliance fails to operate correctly, after checking
that you have followed the user instructions correctly, disconnect
the appliance from the electrical mains and contact your nearest
service centre. Never attempt to repair the appliance.
Warning: Close the cable clamp after making the electrical
connection. Close the terminal board cover by twisting it down.
To Next Page
Loading...
