8
Use and Care
HOBS WITH CONTROL KNOBS
Description of symbols
Single cooking zones
Turn the control knob to the desired position (low to high).
Adjustment is continuous so the cooking zone will operate at any
intermediate knob setting between low & high. Once the cooking
zone is hot, the LED corresponding to the zone illuminates.
You can switch off the cooking zone by turning the knob, in either
direction, to the off position. The residual heat warning light
remains illuminated when the temperature of the ceramic glass
surface is hot and it will switch off once the surface temperature
has cooled.
Dual cooking zones
Turn the control knob clockwise to the desired position between low
and halfway as shown on the diagram on page 9. The inner cooking
zone will heat and the outer cooking zone is off. Adjustment is
continuous so the cooking zone will operate at any intermediate
knob setting between low & halfway. Once the inner cooking zone
is hot, the lamp corresponding to the zone illuminates.
To operate the outer cooking zone, turn the knob past the half way
setting. Both inner and outer cooking zones will operate.
Adjustment is continuous so the both zones will operate at any
intermediate knob setting between halfway & max. For highest
setting with both zones operating, turn the knob past max, to the
detent position (between max & ). To reduce heat setting, but
continue to operate both zones, turn the knob anywhere between
maximum and halfway setting.
To return to operating the inner cooking zone only, turn the knob
anticlockwise to between halfway and low.
Front
Left
Rear
Left
Rear
Right
Front
Right
Off
To Next Page
Loading...
