4
FIRST TIME USE
INITIAL SCAN
When your radio is switched on for the rst time it will
scan all usable stations and store them alphanumerically
- 1 Radio, 2 Radio, AA Radio, AB Radio... The initial scan
will take a few minutes. After the scan, the number of
stations found will be displayed, and the radio will play
the rst station in the sequence.
Note: If no stations are found, switch the radio o and
move it to a location with a stronger signal. When you
switch the radio back on it will automatically repeat
the scan process.
SETTING THE CLOCK
Automatic clock setting:
The clock on your radio is automatically set from the
time signal broadcast with DAB radio stations.
Manual clock setting:
If DAB reception is not available in your area, you can
set the time manually via the menu as follows -
Press the • MENU button.
Press the • NEXT button repeatedly, until <SYSTEM>
is displayed.
Press the • Volume/Select control.
<Time> is displayed.
Press the • Volume/Select control.
<Set Time/Date> is displayed.
Press the • Volume/Select control.
Set time will be displayed, the hour digits will ash.
Press the • NEXT/PREV buttons to set the hour
correctly.
Press the • Volume/Select control.
Repeat the last two steps to set the minutes, then •
the date.
NOTE: Manual time and date settings will be
automatically updated if the radio receives a DAB
broadcast.
NOTE: If the radio is disconnected or there is a power
loss, time and date settings will be lost until next time
a DAB radio is tuned or the clock is manually set.
To Next Page
Loading...
