17
461306303 (A-000)
L
C
L
C
P
M
OVEN CAVITY
Do not spray or wash the thermostat bulb with
acid based products (check the product label
before use). The manufacturer cannot be held
liable for any damage caused by incorrect
cleaning.
The oven cavity should be cleaned after each use
to remove cooking residuals and or grease or sugar
which, if burnt on when the oven is used again, will form
deposits or unremovable stains as well as unpleasant
smells. The oven MUST always be cleaned whilst it is
warm with warm soapy water.
To maintain the shine of the enamelled parts, clean
them with warm soapy water, rinse and dry them
thoroughly. DO NOT wash these parts if they are still
hot and NEVER use abrasive powder cleaners and
pads. DO NOT leave vinegar, coffee, milk, salty water
or the juice of lemon or tomato on enamelled surfaces
for any length of time. ALWAYS wash the accessories
used.
OVEN SEAL
The oven seal guarantees the correct functioning of
the oven. We recommend you:
• clean it, avoiding abrasive tools or products.
• check its state now and then.
If the oven door seal has become hard or is
damaged, contact our Service Centre and avoid
using the oven until it has been repaired.
10a
10b
INSTRUCTIONS FOR THE USER
REPLACING THE OVEN LAMP (fi gs. 10a - 10b)
Ensure the appliance is switched off before
replacing the lamp to avoid the possibility of
electric shock..
In the event oven lamp need replacing, the new lamp
must comply with the nominal data indicated on page
14 and must be resistant to high temperature (300°C).
Turn glass protection cap (C) counterclockwise and
change the lamp. Re-fi t the cap, screwing it back in a
clockwise direction.
To Next Page
Loading...
Need help?
General
