9
461306303 (A-000)
DESCRIPTION OF THE APPLIANCE
1 2 3 4 5
F
ELECTRONIC PROGRAMMER (ref. F
The programmer can select the following functions:
- Clock
(set by keys 2 and 3)
- Minute counter
(set by key 1)
- Cooking time
(set by key 2)
- End of cooking
(set by key 3)
- Manual operation mode
(set by keys 2 and 3)
- Setting time backwards
(set by key 4)
- Setting time forward
(set by key 5)
The digital display always shows the time and can be
set to show cooking time or end of cooking count-down
simply by pressing the corresponding key.
Please Note: When the cooking session is over the
programme automatically turns off the oven (except
for the timer). Should you wish to proceed manually
next time you use the oven, make sure you set the
manual operation function (see instructions further
on).
Setting the time( 0:01 to 24:00 = hh,mm)
When plugging in the appliance the fi rst time or
subsequent a power cut, the display shows both “A”
and “0.00” (or the minutes past the power failure) signs
fl ashing.
To reset the time push keys 2 and 3 simultaneously
then press key 4 or 5 till you reach the exact current
time. When done, the “A” symbol turns off and the
manual operation symbol is lit.
Manual operation
Each time the time is set, the programme
sets automatically on manual working order.
The only other case when this occurs is when an
automatic programme reaches completion, or has
been cancelled by pressing keys 2 and 3 at the same
time. The “A” symbol disappears and the turns on.
Minute counter ( 0:01 to 0:59 = hh,mm)
Press key 1 and select cooking time by pushing key 4 or
5. Symbol turns on. Once the time set is expired the
acoustic alarm rings and turns off.
Semi-automatic operation
(with cooking time from 0:01 to 23:59 = hh,mm)
Press key 2 and set cooking time by keys 4 or 5; both
symbols “A” and are lit. Once the set period is
over, turns off, “A” fl ashes and the buzzer rings.
Semi-automatic operation
(with end of cooking time from 0,01 to 23,59 = hh,mm)
Press key 3 and set the end of your cooking session
by key 5; both symbols “A” and turn on. Once the
set hour is reached, turns off, “A” fl ashes and the
buzzer rings.
Automatic operation
(with the start of cooking time delayed)
Set the cooking period fi rst ( “A” and turn on)
then set the end of cooking time ( turns off) as
previously described. Symbol turns on again
when at the start of cooking session. When cooking
time is over, turns off, “A” fl ashes and the buzzer
will advice cooking completion.
Buzzer
The buzzer starts ringing when a cooking session has
reached its completion or the timer countdown is over.
It can ring up to 7 minutes. Press any function key to
make it stop beforehand.
Programme start and control
The programme starts immediately after setting.
To check settings of the programme press the
corresponding key.
Correcting/cancelling the programme setting
In case the current time displayed on the clock is
within the cooking period set, an error in the automatic
function occurs, and both the buzzer ring and the
fl ashing «A» draw your attention. Such error in the set
up can be amended by varying the cooking time length
or its end. Any programme set can be modifi ed at any
time by pressing fi rst its corresponding programme key
and then key 4 or 5. To cancel a programme, correct
the time set bringing it to a value of “0.00”. When
functioning time is cancelled the end of functioning
is cancelled too and vice versa. The oven turns off
automatically and the “A” symbol fl ashes.
To Next Page
Loading...
Need help?
General
