TROUBLESHOOTING
If your camera does not work as expected please run through this checklist before you contact Tesco.
Camera will not turn on
1. Batteries are not properly installed- remove and reinstall the batteries.
2. Insufficient battery voltage - Do not use old batteries or batteries with mixed battery life.
Do not use low voltage or low capacity rechargeable batteries
Flash will not fire
1. Flash set to OFF -Set the flash to Auto or On.
2. Flash has not been fully charged The flash takes a few seconds to charge -the Operation LED blinks. The Flash
light is fully charged when the Operation LED turns off.
3. Battery level low - the voltage is too low for the flash to work. Insert new batteries.
Image is blurred or out of focus
1. Subject is out of focal range. Ensure that there is at least 1.5m (5ft ) between the camera lens and subject.
2. The camera moved- Hold the camera steady while taking the picture.
The PC does not recognize the Camera.
In Windows 98SE, the camera driver has to be installed before downloading.
Subject in recorded image is too dark
Insufficient light for shooting Set the flash ON, or adjust the exposure value to a positive (+) setting.
Flickering on LCD screen or recorded image
Incorrect frequency setting. Check the anti-flicker frequency ( 50Hz or 60Hz ) under fluorescent light.
Flash card does not display images recorded.
The flash card is faulty or improperly formatted. Re-format the SD card and if necessary, replace it.
The SD card is locked. Move the switch at the side of the card to unlock it.
46
To Next Page
Loading...
