To take a picture:
• Line up the shot by looking at the image on screen.
• Keep the camera steady
• Press the shutter button gently
The camera will beep, momentarily go blank and begin to process the image. The picture
you have just taken appears on the screen. Let the camera to process the picture
before lining up the next shot. When the screen clears you can take another picture.
The ‘pictures remaining' indicator on the screen will decrease by one.
Using Flash
• Press the FLASH key to select FLASH off/on/auto.
The indicator appears on the screen
During this period the monitor screen will turn off and the"busy"light blinks.
When the light stops blinking and the screen turns on again, charging is done.
• You are now able to take a flash photograph.
When the shutter is pressed :
The FLASH ON function will always fire the flash.
The FLASH AUTO function will fire automatically as conditions require.
NOTES:
Wait for the light to go steady
before using the camera or
switching off!
BUSY
00100
25/01/2007
SD
5M
READY
BUSY
READY
Because the flash needs to be charged, the rate at which you take successive
pictures is reduced.
Battery life is reduced when using flash photographs.
If you are taking a photo of a distant object by night the flash has no effect.
When taking a shot of a very close object, the flash may "bounce" off the image
and the picture may be affected.
6
00099
25/01/2007
SD
5M
Flash Off
Flash On
Flash Auto
A