GETTING STARTED
Plug in the mains plug and switch the system on at the
mains point.
The system will respond and go into Standby. In
standby mode the display is off so it may appear as if
the unit is not working - it is!
Setting the Clock
When the system is in Standby the screen displays the
clock time. The clock can be set to display 24 or 12
hour (AM/PM mode)
1. Press and hold the PROGRAM key for 3 seconds
2.Press the or keys to toggle 12/24 hr mode.
3. Press the PROGRAM key to confirm
Setting the time 20:25 (24 Hour Mode)
4. Press to set the hour.
3. Press the PROGRAM key to confirm
The hour stops flashing and the minutes flash.
4. Press to set the minutes.
5. Press the PROGRAM key to confirm
The minutes stop flashing and the clock is set.
To set the clock to 12 hour format:
Select ‘12 HOUR ‘ and proceed as above.
• The clock can only be set when the unit is in Standby
The procedure may be carried out from the control
panel or the handset.
SWITCHING ON
Press the POWER switch on the handset or the
ON/OFF switch on the front panel. The unit switches
on. In normal use the system will revert to the mode and
volume it was in when last used.
SELECTING AN INPUT
Repeatedly press the FUNCTION key to select an
input - AUX/ USB CARD/ TUNER/ CD
PLAYING A CD
1. Select CD via the FUNCTION key : OR
Press the PLAY/PAUSE key.
If no disc is in the player you will see:
2. Press OPEN/CLOSE to open the CD door
3. Place a CD into the tray with the label facing
outwards.
4. Press OPEN/CLOSE to close the CD door.
5.The player will read the disc Table of Contents (TOC)
The display will register the disc information and stop.
(A very few CDs may begin playing from Track 1.)
If the disc is a standard audio CD the display will show
“CD”. Other formats will display the format type.
These behave differently and will be covered later.
ANTI SHOCK PROTECTION (ESP): The player uses
a memory buffer. The buffer memorises up to 40
seconds of information and reads from this memory to
prevent skipping when the unit is subjected to minor
shocks and vibration. If you the unit is in a location
where there is no likelihood of shock and where it will
not be moved during play, you may switch ESP off.
Press the FIND/ESP key to toggle ESP ON and OFF.
OPERATION PLAYING A CD
8
24 hour
20:00
12 hour
24 hour
20:25
20:25
Hello
O
D SC
CLOSE
CD READ
VOLUME
VOLUME
VOLUME
VOLUME
09 64:57
ESP
VOLUME
09 64:57
ESP
VOLUME
09 64:57
ESP
ESP ON
ESP OFF
OPE
VOLUME
To Next Page
Loading...