TechniSat DIGIT MF4-S - Deleting Existing Limits; Setting the Eastern Limit; Setting the Western Limit

If there are no obstructions in the rotating radius of the dish, set the
limits so the dish can be rotated a little beyond what is required for
the outermost satellite you wish to receive.
9.1.1 Deleting existing limits
First you should delete any limit values that may have been stored.
> Use the arrow keys left/right to mark the column LNC
Test.
> Now use the arrow keys up/down in the line Rotating
antenna, and mark the field Continue.
> Confirm by pressing OK.
The menu used for setting the rotating antenna will now be
displayed. (Fig. 9-4)
> Press the yellow function key Actions to open an
additional window. (Fig. 9-5)
> Now use the arrow keys up/down to mark the line
Delete limits.
> Confirm by pressing OK to accept the action selected to the
green function key.
> To delete the limits set,press the green function key Delete
limits.
> Confirm the prompt displayed (Fig. 9-6) by pressing OK.
9.1.2 Setting the Eastern limit
> To enter the Eastern limit, first use the arrow keys to mark
the field Save.
> Now use the arrow key right to turn the dish to the
maximum possible, resp. the maximum desired East
position.
> Press the yellow function key Actions to open a window
with the available actions.
> Now use the arrow keys up/down to mark the line Set
East limit.
> Confirm by pressing OK.
> To set the easterly limit, press the green function key (East
limit) and confirm the following screen prompt (Fig. 9-7) by
pressing OK.
9.1.3 Setting the Western limit
> To enter the Western limit, first use the arrow keys to mark
the field Save.
> Now use the arrow key left to turn the dish to the
maximum possible, resp. the maximum desired West
position.
> Press the yellow function key Actions to open a window
56
(Fig. 9-6)
(Fig. 9-7)
(Fig. 9-4)
(Fig. 9-5)