TechniSat DIGITRADIO Car 2

55
DE
EN
1 Reception unit
2 Adhesive antenna
3 Display/control unit
4 2 x AAA baeries for the display/control unit
5 Cleaning cloth
6 Adhesive mount for the display/control unit
7 12 V power supply for the reception unit
8 Self-adhesive cable clips
9 Microphone with mount for the sun visor
4.2 Installing the DIGITRADIO Car 2
You need to carry out the following steps before you can use your DIGITRADIO Car 2:
1. Connect the microphone to the reception unit
2. Position the reception unit with antenna in your vehicle
3. Position the microphone in your vehicle
4. Connect the reception unit to your vehicle’s audio system - by cable or FM transmission
5. Install the display/control unit
6. Switch the DIGITRADIO Car 2 on for the first time
4.2.1 Vehicle requirements
> Installed audio system with AUX port (3.5 mm) or FM receiver
> Standard 12 V negative earth
Your DIGITRADIO Car 2 is not suitable for use with a 24 V power supply.