37
DE
EN
FR
IT
NL
PL
Switch the device o aer each area has been cleaned. This will significantly
increase the operating time per baery charge. Recharge the baery aer
use.
> Select the accessories as required and aach them to the device.
> Switch the device on by pressing the operating switch (8) once. The device
immediately starts the suction process. The touch display (1) lights up.
> If necessary, the suction strength can be changed manually via the touch
display by touching the “Suction strength” field. The intelligent suction control
can also be set by touching the AUTO symbol.
> Move the device over the area to be cleaned.
> If you want to switch the device o again, press the control switch once
more.
8.1 Emptying the dust holder
Remove the dust holder from the motor unit to facilitate emptying.
> Hold the dust holder over an open bin. The distance to the bin should be as
small as possible so that the dust is not dispersed into the surroundings.
> Press the emptying buon (5) on the dust holder. The lid of the dust holder
opens and the dirt falls out.
> Press the lid onto the dust holder to close it. The tab must engage audibly.
To Next Page
Loading...