EN3
Press “MODE” button to confirm your setting, the language selection for the Weekday displays starts
to flash. Now use “+” and “-” buttons to select a language.
Press “MODE” to confirm your setting and to end the setting procedures and enter the clock mode.
Please note:
After 20 seconds without pressing any button, the clock switches automatically from Set Mode to
Normal Time Mode.
Setting the alarm
Press “+” button once, LCD displays the “ ” icon, the alarm function is ON. Then press once “+”
button, the “ ” icon will disappear from the display, the alarm function is OFF.
Press “MODE” button once, LCD displays alarm (default 6:00 AL) time. Then press and hold “MODE”
button for 2 seconds until hour of the alarm time starts to flash. Use the “+” and “-” buttons to set the
hour. Press “MODE” button to confirm your setting.
The Minute of the Alarm time starts to flash. Use the “+” and “-” buttons to set the minute. Press
“MODE” button to confirm your setting.
The snooze time of the alarm starts to flash. Use the “+” and “-” buttons to set the snooze time. Snooze
time can be set from OFF to 60 minutes.
Press “MODE” button to confirm your setting and to end the setting procedure.
Please note:
After 20 seconds without pressing any button the clock switches automatically from setting mode to
Normal clock mode.
The alarm will sound for 2 minutes if you do not deactivate it by pressing any button. In this case the
alarm will be repeated automatically after 24 hours.
Rising alarm sound (crescendo, duration: 2 minutes) changes the volume 4 times whilst the alarm
signal is heard.
Switching off the alarm signal
Press any button except the “SNZ” button to stop the alarm signal. It is not necessary to reactivate the
alarm. It switches itself automatically to the alarm time which has already been set.
Snooze function
Press the “SNZ” button the alarm signal sounds to get to Snooze mode. The alarm signal sounds
again after
the time that was set for Snooze. If OFF was selected in the Snooze time setting, the alarm will not
repeat.
Switching °C or °F
Press once “-” button to switch the temperature unit to °C or °F.
SPECIFICATIONS
To Next Page
Loading...
Need help?
General
