Why does my Technogel Ice Cream Maker refrigerator compressor stop?
If the refrigerator compressor on your Technogel Ice Cream Maker stops, it could be due to a tripped thermal overload switch. Try resetting it by pressing the pushbutton. Alternatively, the maximum pressure switch might have tripped; ensure there's sufficient cooling water. If the maximum pressure switch is not calibrated or defective, check and adjust it.
What to do if the dasher stops during freezing phase in my Technogel Ice Cream Maker?
If your Technogel Ice Cream Maker's dasher stops during the freezing phase, even if the motor is still running, it could be because the belts that transmit motion to the turbine are too loose. Try resetting the correct draught by adjusting the screws at pos. T. Alternatively, the belts may be worn and no longer transmit movement to the turbine. In this case, replace all the belts; never replace just one.
Why is the freezing time too long in my Technogel Ice Cream Maker?
If the freezing time is too long on your Technogel Ice Cream Maker, it might be due to worn scraping blades limiting thermal transfer. Replace all scraping blades and centring blocks. Another cause could be insufficient refrigerating gas; check and refill if necessary. Also, the thermostat valve might be too tightly closed; open it or replace it if blocked.
What to do if the dasher motor stops during ice-cream removal in my Technogel Ice Cream Maker?
If the dasher motor stops during ice-cream removal from your Technogel Ice Cream Maker, it could be because the ice-cream is too thick. Reset using the triggering overload cutout switch. It may also be that the machine has passed from the freezing stage to evacuation passing via STOP. Pass immediately from freezing to the evacuation without pressing STOP.
Why does my Technogel Ice Cream Maker stop and the control console switch off?
If your Technogel Ice Cream Maker stops during a work cycle and the control console switches off, the front door safety switch may be broken. Replace the switch at pos. S.
Why does the "Ice-cream ready" buzzer ring repeatedly on start-up of my Technogel Ice Cream Maker?
If the "Ice-cream ready" buzzer rings repeatedly on start-up of your Technogel Ice Cream Maker, the electronic gear-case may have been calibrated too low. Increase the value stored in gear-case. It could also be a faulty amperometric gear-case. Check and/or replace it.
General| Brand | Technogel |
|---|---|
| Model | Mantegel 20 |
| Category | Ice Cream Maker |
| Language | English |
To Next Page
