Technogym M5800-AN19GZ

Need help?

Do you have a question about the Technogym M5800-AN19GZ and is the answer not in the manual?

Summary

2. TECHNICAL CHARACTERISTICS

2.2. MECHANICAL CHARACTERISTICS

Physical dimensions and weight specifications of the Kinesis ONE machine.

2.3. AMBIENT SPECIFICATIONS

Recommended temperature and humidity ranges for operating and storing the machine.

5. INSTALLATION AND HANDLING MACHINES

5.1. SPECIFICATIONS AND REQUIREMENTS

Requirements for machine installation: surface, environment, and capacity.

5.2. INSTALLATION

Machine delivery state and reference to the installation manual for assembly.

6. DISASSEMBLY PART

Identifying Left and Right Sides

6.1. REAR PANEL DISASSEMBLY

6.2. FRONT PANEL DISASSEMBLY

6.3. REAR CABLE DISASSEMBLY AND REASSEMBLY

Procedure for rear cable disassembly and reassembly, including routing and securing.

6.4. REMOVING WEIGHT STACK CABLE (HANDLES)

Procedure to remove weight stack cable and handles by lifting plate and extracting retainer.

6.5. ARMS DISASSEMBLY

6.6. PULLEY DISASSEMBLY

6.7. CAM DISASSEMBLY

6.8. ROTATING PULLEY SYSTEM DISASSEMBLY

Procedure to disassemble rotating pulley system, remove guards, and pulleys.

6.9. WEIGHT STACK DISASSEMBLY

Procedure to disassemble weight stack by loosening stops and tilting the stack.

6.10. FOOT ADJUSTMENT DISASSEMBLY

7. ADJUSTMENT

7.1. THE WEIGHT STACK IS NOT FLOWING FLUID

Troubleshooting weight stack fluid movement by cleaning and lubricating bars and bushings.

7.2. THE CABLE OF WEIGHT STACK IS NOT IN TENSION

Procedure to adjust weight stack cable tension by manipulating pulley nuts and screws.

7.3. ADJUSTING THE FRONT PANEL POSITION

7.4. THE MACHINE IS NOT FLAT

Procedure to level the machine by adjusting foot heights using a 19mm wrench.

7.5. ADJUSTMENT WEIGHT STACK STOP

8. SCHEDULED MAINTENANCE

8.2. EXTRA-ORDINARY MAINTENANCE OPERATIONS

8.2.3. REPLACING THE CABLES

Recommended frequency for replacing machine cables based on usage intensity.