Technoline BC-700 User Manual (English)

To Next Page

BC-700 charger

Charger have four individual charging channels. It can charge 1 to 4 pcs of NiMH / NiCd

AA or AAA. You can select different mode for each of the 4 channels.

Modes you can select:

Charge

Charger use such current as: for AAA: 200mA, 500mA, 700mA; for AA: 200mA, 500mA,

700mA.

Charge mode is controlled by the processor which detects -dV and controls the

temperature during this mode. Charge is terminated if the tempreture is higher then 53

Discharge

You can discharge batteries with use of such current as: 100mA, 200mA, 350mA. After

discharging the charger starts to charge up the batteries with current twice as stronger

as the current selected for discharging.

Refresh

This mode can refresh old batteries. Charge and discharger are repeated till the batteries

will regain their full capacity.

Test

Charge and then discharge with measuring the capacity of the batteries.

Rechargeable cell: not included

Need help?

Do you have a question about the Technoline BC-700 and is the answer not in the manual?

Technoline BC-700 Specifications

General

Charger uses specific currents for AAA (200-700mA) and AA (200-700mA). Charge mode is processor-controlled and temperature-limited.

Discharges batteries using 100-350mA, then recharges with double the selected current. Processor controls discharge.

Refreshes old batteries by repeating charge and discharge cycles until full capacity is regained.

Tests batteries by charging then discharging while measuring capacity.