EN19
Once to show the maximum temperature and humidity values.
Twice to sow the minimum temperature and humidity values.
Three times to return to the current temperature and humidity levels.
To reset the maximum and minimum temperature and humidity, press and hold down
the “MEM” button about 2 seconds. This will reset all minimum and maximum data
recorded to the current displayed values.
Notes:
If the temperature reading is below ranges, the LL.L will be displayed. If the tem-
perature reading is above ranges, the HH.H will be displayed.
If the humidity reading is below ranges, the 19%RH will be displayed. If the humidi-
ty reading is above ranges, the 96%RH will be displayed.
Background lighting
When the station is powered by batteries:
Press the “ ” touch field once and the backlight will light up with highest
brightness for 15 seconds. This will not work when you are already using the back-
light with the highest available brightness.
When the station is powered by the USB cable:
Press the “ /SET” button to adjust the brightness of the backlight, you can ad-
just to one of 4 levels: 3 different backlight brightness levels or turning off the back-
light.
Explanation of the network weather forecast
After the base station is connected with the WIFI hotspot, the weather information
of the base station will be updated automatically every hour after the weather fore-
cast information obtained from the network.
The base station automatically downloads real-time air pressure, weather fore-
casts for today and the next three days, and forecasts of the highest and lowest
temperatures from the network.
The base station automatically uploads the data of indoor and outdoor temperature
and humidity from the base station to the server, and the APP can download the
data automatically from the server through the network.
If you use battery power, the weather station will automatically connect to the WIFI
once an hour to implement the above network data upload and download. If you
use DC power from USB cable, the WIFI connection will always work.
To Next Page
Loading...
