Technoline WS 6730 - Page 15

6
8.1 RF Transmission Procedure:
 The main unit automatically starts receiving transmission from outdoor thermo
sensor for outdoor temperature after weather condition setting.
 The thermo sensor unit will automatically transmit signal to the main unit after
batteries inserted. For having more than one external transmitter (Maximum3),
select the Channel, CH1, CH2 or CH3 to ensure each sensor is transmitting
difference channel before inserting batteries. The channel select switch (D6) is at
the back of the thermo sensor.
 If main unit failed to receive transmission from outdoor thermo sensor in first 3
minutes after the batteries inserted (“- - . –”display on the LCD), hold “Channel”
button (B12) for 3 seconds to receive transmission manually. RF icon “ ”
flashes on the LCD
Note: “HISTROY” (B6), “▲” (B7), “▼”(B8), “REL/ABS”(B9), “C/F”(B10),
“MAX/MIN” (B11) buttons will not function while scanning for thermo sensor’s signal.
8.2 Temperature & Humidity
(1) Outdoor Temperature--- Channel Selection
 Press “CHANNEL” button (B12) to view the 3 Channels’ temperature & humidity.
The sequence is shown as follow:
PRESS “CHANNEL” button PRESS “CHANNEL” button PRESS “CHANNEL” button
Display the three
channels alternatively
 When viewing the record on CHANNEL 1 or 2, or 3, hold “CHANNEL” button (B12)
for 3 seconds to cancel the record on this channel manually, and receive the
transmission automatically again.
(2) Maximum / Minimum Temperature and Humidity
 Press “MAX/MIN” button (B11) to show the maximum recorded Indoor /Outdoor
Temperature and Humidity. “MAX” is shown on the LCD
 Press “MAX/MIN” button again to show the minimum recorded Indoor/Outdoor
Temperature and Humidity. “MIN” is shown on the LCD.
(3) Outdoor Temperature Trend
 The trend pointer (A14) displayed on the LCD indicates the trend of the outdoor
temperature.