Technoline WS 6730 - Page 16

7
Indicating the outdoor
temp. is rising
Indicating the outdoor
temp. is steady
Indicating the outdoor
temp. is falling
(4) Outdoor Humidity Trend
 The trend pointer (A13) displayed on the LCD indicates the trend of the outdoor
humidity.
Indicating the outdoor
humidity is rising
Indicating the outdoor
humidity is steady
Indicating the outdoor
humidity down
(5) Celsius / Fahrenheit
 Press “°C /°F” button (B10) to select Indoor/Outdoor Temperature in Celsius
mode or Fahrenheit mode.
 If the temperature is out of the measurable range, LL.L (beyond the minimum
temperature) or HH.H (beyond the maximum temperature) will be shown on the
LCD.
9. Time and Alarm Setting
9.1 Radio Controlled Clock:
 At 2 minutes after the start-up of the unit, the clock automatically starts to scan
the DCF time signal. Radio Control Icon “ ” (A1) flashes on LCD.
(A1) flashes，
Indicating now is receiving
DCF signal
(A1) turns on,
Indicating signal received
successfully
(A1) disappear,
Indicating signal reception
failed
 The clock automatically scans the time signal at 3.00 a.m. every day to maintain
accurate time keeping. If reception fail, scanning stops (“ ” on LCD disappear)
and repeats again at 4.00 am, 5am, and 6 am.
 The clock can be set to scan the time signal manually by holding “ ” button (B5)
for 3 seconds. Each reception takes about several minutes. If reception fail,
scanning stops (“ ” disappear on the LCD) and repeats again on next full hour.