9
9.4 Dual Daily Alarm Function:
Press “ MODE” button (B1) to select to view:
Time Alarm Time1 (Alarm Icon“ “flash on the LCD) Alarm Time2
(Alarm Icon “ “flash on the LCD)
When viewing Alarm Time 1 or Alarm Time 2, hold “MODE/SET” button (B1) for
3 seconds to enter that Alarm Time setting. Press “+” (B4) or “-” (B5) button to
adjust the alarm time, press “MODE/SET” button (B1) to confirm the setting.
When viewing Alarm Time 1 or Alarm Time 2, press “AL ON/FF” (B3) button to
switch that alarm ON or OFF. If it is on, alarm icon “ ” or “ ”will be shown
on the LCD.
When Alarming, press any of “MODE/SET” (B1), “AL ON/OFF”(B3), “+ (12/24)”
(B4), or “-/ ” (B5) button to stop the alarm.
When Alarming, press “SNOOZE / LIGHT” button (B2) to activate the snooze
alarm, alarm icon (“ ” or “ ”) flashes on LCD. The alarm will snooze for 5
minutes, then it alarms again. This snooze function can be enabled for maximum
7 times. .
Press any of “MODE/SET” (B1) “AL ON/OFF” (B3), “+/ (12/24)” (B4) or “-/ ” (B5)
button to stop the snooze alarm.
10. Low battery indication:
The low battery icon “ ”will appear at particular channel indicating that
thermo sensor unit of the channel is in low battery status. The batteries should
be replaced.
11. Backlight
Press “SNOOZE/LIGHT” button (B2), back light states for 5 seconds.
12. Precautions
Use a pin to press the reset button (B13).
To Next Page
Loading...
