Technoline WS 6760 - Weather Station Component Overview

EN7
Information:
 The clock automatically changes from set-up mode to time mode if no keys are pressed for
20 seconds.
 The alarm sounds for 2 minutes if no key is pressed to stop it.
Snooze function
To activate the snooze function, follow the steps below
 Press the key “SNOOZE/LIGHT“, while the alarm sounds, to activate the snooze function.
 If the snooze function is activated, alarm symbol is flashing.
 The alarm repeat after 5 minutes.
 The snooze function can be stopped by pressing any other key.
12/24 hours mode
 The time can be displayed in 12（AM/PM）or 24 hours mode.
°C/°F temperature display
 The temperature can be displayed in °C or °F. Press the key “-“ to switch between °C and
°F.
Max./ Min. for the indoor/outdoor temperature and humidity
 Press “+” for displaying of indoor/outdoor max./min. of temperature and humidity.
Temperature alert set-up
 Press “Channel” to select the channel (CH1, CH2, CH3) if more than one outdoor sensor is
used
 Press and hold the key “-” then select between ON/OFF.
 Press “MODE” , the upper limit temperature is flashing, use “+” , “-“ to set the maximum alert
temperature.
 Press “MODE “, the lower limit temperature is flashing, use “+” , “-“ to set the minimum alert
temperature.
 When the alert is activated, the alert symbol will be shown on the left of the
outdoortemperature display
.
Temperature alert on/off
Press and hold the key “-“ to set the temperature alert on or off.
 Alert on: Temperature alert symbol shown in display
 Alert off: Temperature alert symbol is not displayed
Information
 A temperature alert can be set-up for each channel.
 The set-up process cannot be completed if the maximum temperature selected is lower than
the minimum selected temperature.
 The minimum temperature selected must at least be 1°C below the maximum selected
temperature.