EN9
If the unit received DST signal, the unit will display “DST” icon. If the unit did not received
radio-controlled time signal, the “DST” icon does not disappear unless it received no DST signal.
If there is no signal or too much interference the receiver will only be on for 2 minutes.
If the signal is good the reception will finish in 2-3 minutes.
If the signal is weaker the reception will run for up to 10 minutes.
Manual reception of DCF:
In normal display mode, press the RCC button to on/off time signal search. The DCF reception icon will
be flashing while the reception of the DCF signal is active and the icon will no longer be displayed
when the reception is turned off.
Manual setting:
- Press and hold the MODE button in normal display mode to enter setting mode:
To Next Page
Loading...
