Technoline WS8055 User Manual

ALARM SETTING
The maximum alarm duration is 80 seconds. To set the alarm function:
1. Press the ALARM key for about 1 second or until the digits start flashing in the LCD
to enter into the Alarm setting mode. The hour digits start flashing.
2. Press the + key to set the hour.
3. Press the ALARM key to enter the minute mode. The minute digits start flashing.
4. Press the + key to set the minutes.
5. Press the ALARM key or the SNOOZE/LIGHT key to exit the Alarm setting mode or
wait for 15 seconds automatic timout.
Note:
If the ALARM key is pressed for a short time, the alarm toggles between ON/OFF. At the
same time, the current alarm time will be displayed together with E.L. back light ON for
about 4 seconds.
TO ACTIVATE / DEACTIVATE THE ALARM:
The alarm will automatically be ON upon entering and exiting the Alarm setting mode. To
desactivate the alarm (OFF), use the ALARM key in normal mode display.
SNOOZE SETTING
When pressing the SNOOZE/LIGHT key during alarm sounding, the snooze function
is activated for a duration of 9 full minutes and the E.L. back light will be ON for
about 4 seconds.
When keeping the SNOOZE/LIGHT key during alarm sounding for 1 second, after
confirmation of a "beep“ sound, the alarm will switch OFF for the next 24 hours and
no snooze function will be activated.
Note:
If the SNOOZE/LIGHT key is pressed shortly anytime, except during alarm ringing, it will
activate the E.L. back light for 4 seconds
If the SNOOZE/LIGHT key is pressed for about 1 second, except during alarm ringing, it
will display the alarm time together with the E.L. back light ON for about 4 seconds.
CARE AND MAINTENANCE
Avoid placing the unit in areas prone to vibration and shock as these may cause
damage.
Avoid areas where the unit can be exposed to sudden changes in temperature, i.e.
direct sunlight, extreme cold and wet/moist conditions as these will lead to rapid
changes which reduces the accuracy of readings.
When cleaning the LCD and casing, use a soft damp cloth only. Do not use solvents
or scouring agents.
Do not submerge the unit into water.
Immediately remove all low powered batteries to avoid leakage and damage.
Replace only with new batteries of the recommended size.
Do not make any repairs to the unit. Please return it to the original point of purchase
for repair by a qualified engineer. Opening and tampering with the unit may
invalidate its guarantee.

Technoline WS8055 Specifications

Operating Environment

indoor temperature measuring range (Celsius)	0ºC to +50ºC
indoor temperature measuring range (Fahrenheit)	32ºF to +122ºF
indoor temperature checking interval	every 10 seconds

Power

power source	2 x AA, IEC LR6, 1.5V batteries
battery life	about 12 months

Weight and Dimensions

dimensions (L x W x H)	118 x 50 x 100mm