P. 4
TO DISPLAY INDOOR TEMPERATURE
Simply press SNOOZE once, the time display will change to temperature display. Press SNOOZE
once to return to time display.
Press and hold SNOOZE for 2 seconds, your clock gives a short beep and will display time for 10
seconds and then display temperature for 5 seconds alternately. Press and hold SNOOZE will cancel
this and return to normal time display mode.
Mode 1:Time display
Mode 2:Temperature display
Mode 3:Press and hold SNOOZE:10 seconds time display ,5 seconds temperature display
TO USE THE DIMMER FUNCTION
Press / DIMMER once to adjust the High / Low brightness of the display.
TROUBLE SHOOTING
If your clock displays irrelevant time or does not function properly, which maybe caused by electro-
static discharge or other interference, unplug the DC jack to disconnect the AC power (and remove
the backup battery). The clock will be reset to default settings and you need to set it again.
CARE OF YOUR LED ALARM CLOCK
1. Do not expose the unit to extreme temperature, water or direct sunlight
2. Avoid contact with any corrosive materials
3. Do not subject the unit to excessive force, dust or humidity
4. Do not open the inner back case or tamper with any components of this unit
5. Do not plug in any other AC/DC adaptor with incorrect specifications or voltage
SPECIFICATIONS
Operation Temperature: 0°C to + 45°C
Indoor Temperature Display Range
0°C to +45°C
Temperature Resolution 1°C
Alarm Duration 1 hour
Snooze Duration 5 minutes
AC/DC adaptor voltage 5,5 V
To Previous Page
Loading...
Need help?
General
