Safety Measures
• Keep the mouse away from young children.
• Any attempt to disassemble, adjust or repair the mouse may result in
exposure and other safety hazards.
Button Count: 5 buttons
Operating Frequency: 2.4GHz
Resolution: 800/1200/1600DPI
Receiver interface: USB version 2.0
Operating Voltage: 1.5V
Operating Current: 10mA
Distance: upto 10m
1.What do I do if the mouse does not work?
• Check whether the low power indicator on the top of the mouse lights
up. If the sensor lights up, it is likely that the batteries are discharged.
Please replace them.
• If replacing the batteries does not help, it is likely that the mouse is not
connected to the receiver.Please try“Reconnection”.
Attention
1.To maximize battery life, it is recommended you use the mouse on a
white or light colour surface.
2.If not used, the mouse will drop into auto-sleeping mode within 3
seconds. Press any key or scroll wheel to activate the mouse.
3.Do not use the mouse on a glass or mirrored surface, as these surfaces
will cause the mouse to fail temporarily.
4.The mouse might not work smoothly on some special surfaces, such as
smooth, dark or black, reflecting and 3D mouse pads surfaces.
5.Avoid using the mouse on a metal surface. Metals, such as iron,
aluminium or copper, shield the radio frequency transmission and may
slow down the mouse presenter’s response time or cause the mouse to
fail temporarily.
6.If your PC has a metal case that containsaluminium or magnesium, use
the mouse to the side. The display panel may interfere with the radio
frequency signal if you use the mouse directly in front of the PC.
7.Please remove the batteries if you are not going to use it for a
prolonged period of time (several weeks or months).
Note on handling batteries
• Keep batteries out of the reach of children.
• Replace old or weak batteries promptly.
• Remove the batteries if the mouse is not going to be used.
5
1. Unplug the Nano receiver from USB port, and plug it back in.
And remove the AA battery from the mouse, and re-load it back in.
2. Move the Mouse to within 50cm of the Nano receiver or re-install the
battery or press any key to reconnect; the above process must be
completed in 15 seconds.
3. Mouse will ready for use after reconnection.
To Next Page
Loading...
