To pair the device
1. Plug in the receiver.
2. Press the Music + (the top button) and the volume buttons (central circle) together,
the LED will light up.
3. Then release the buttons simultaneously.
4. While the LED is on, press the transmitter button once, the LED on the receiver will
flash once.
5. Afterwards, press the volume button (central circle) again to finish pairing.
EN
Delete pairing method
1. Unplug the receiver.
2. Press and hold the volume button (central circle) and plug the receiver in. DO
NOT release the button for 5-10 seconds, meanwhile the LED will start flashing.
3. Then release the button after LED turns off.
4. The previous paring mode is removed and confirmed when you hear a ring tone.
Receiver and Transmitter Installation
Apply the double-sided adhesive tape on the back of receiver/transmitter case.
Remove the outer side of tape, attach the receiver / transmitter to the position you
need and press hard for 32 seconds.
To Next Page
Loading...