Tecno Nuova Mapa User Manual

1
Instructions for adjusting the bed height position of the Nuova Mapa manual
telescopic table leg. (Coast part number 400-02600)
This table leg has a maximum height from floor to underside of table top of 710mm.
The bed position is factory set at 330mm, this measurement is taken from the underside of the table top to
the floor. It is possible to adjust the bed position height by following the below steps.
1 – Press the black base knob and open the table to full height.
2 – Unscrew the three screws that are securing the plastic cover at the top of the table leg.
1
“More information https://www.caravansplus.com.au"

Tecno Nuova Mapa Specifications

General

Brand	Tecno
Model	Nuova Mapa
Category	Caravans
Language	English

Summary

Nuova Mapa Telescopic Table Leg Height Adjustment

Open Table to Full Height

Press the black base knob to open the table to its full height.

Remove Top Plastic Cover

Unscrew the three screws securing the plastic cover at the top of the table leg.

Expose Internal Components

Lower the plastic cover to expose the internal metal components.

Locate Adjustment Mechanism and Measurements

Locate adjustment nut and bolt and range of measurements for setting height.

Required Tools

Identify required tools: vice grips and an 8mm socket spanner.

Undo Adjustment Nut

Hold the bolt with vice grips and undo the nut.

Reposition Bolt for Height Adjustment

Remove bolt, reposition bolt and nut in desired hole for height adjustment.

Tighten Adjustment Nut

Hold bolt in new position and tighten nut with socket.

Replace Top Plastic Cover

Replace plastic cover and reinstall the three screws.

Installation and Usage Notes

Notes on securing the base, aligning the cover, and weight rating.